Service of rubber bands
It is no secret that belts are produced in wide rolls, and it is natural that they reach the end user in the required width after longitudinal dissolution. Considering the fact that it is possible to make a high-quality cut only on special equipment, pay attention to errors when cutting the tape you purchased.
Straightness is obligatory (no arc cutting) to avoid problems during subsequent detuning on the conveyor. The quality of the cut should be constant, not creating jags and protruding flaps of the frame. They can wrap around the shaft over time and create additional stress on the drive. Entrust this process to the professionals of the START-UP company, so as not to waste extra efforts and resources.
Separately, it is worth mentioning the perforation of tapes. For bucket elevators, where buckets are attached to the belt, the perforation error is important while observing the row spacing and the center-to-center distance of the holes. High quality of the edge of the holes, constant diameter, no threads sticking out of the hole and pieces of rubber will allow you to quickly and easily mount the buckets on the belt.
Our capabilities are at your service!
- OOO ''СТАРТ-АП'' Украина, 61038, г. Харьков, шоссе Салтовское, 43, Г-3, офис 101
- +38 (067) 446-26-20
Service of polymer tapes
Our service division provides joining of conveyor belts by hot vulcanization without thickening at the joint and without losing elasticity.
As an additional service, it is possible to connect the belt directly on the customer’s conveyor, thanks to the use of a portable air-cooled heat press. The entire docking process, together with preparation, usually does not exceed 1-1.5 hours in time, which minimizes the downtime of the conveyor.
If the structure of the conveyor does not allow the installation of a ready-made endless belt or such joining is impractical for other reasons, you can install a mechanical joint (alligator) on the belt.
In addition to joining, our specialists manufacture complex belts with guides, sides and partitions (pushers, crossbars) and, in certain cases, can repair belts that have already been in operation.
The range with which the service of polymer belts works:
- belts with polyurethane coating (TPU, PU)
- PVC coated tapes (PVC)
- partitions for PVC and PU belts
- guide profiles (6×4, 8×5, 10×6, 13×8, 17×11)
- corrugated boards on a substrate (Compart)
All works are carried out with the help of specialized equipment by a team of qualified specialists of START-UP, LLC.
Repair services for engines, gearboxes
Our company works as a customer service department.
We offer both individual service solutions and comprehensive equipment support throughout the entire life cycle.
The technical base of the service has specialized tools and devices for maintenance and overhaul, namely:
• induction heater;
• mechanical and hydraulic pullers;
• stationary press;
• laser device for shaft alignment;
• laser devices for alignment of pulley flatness;
• V-belt tension meter;
• torque wrenches
This is not a complete list of tools that allow you to carry out high-quality diagnostics and repair of your equipment.
The car park of the service center is able to fully satisfy the customer’s requirements.
Our own warehouse of original spare parts and operational logistics allow us to supply the necessary system part in the shortest possible time, all goods are accompanied by quality certificates.
Qualified service center engineers have many years of practical experience. All parts installed in the process and work performed are guaranteed.
Services provided by the service center:
• diagnostics of electric motors, gearboxes;
• replacement of damaged or worn parts (cuffs, bearings, gears);
• rewinding of electric motors;
• if necessary, repair of the body, welding, grooving, grinding.
• restoration of paintwork;
• grease change;
• assembly of equipment, observing tightening torques, running in.